Banquet draft tower – for all your office party needs

Banquet Tap tower

I built this banquet tap tower for Michelle’s office christmas party in December. It’s a simple block of CVG Douglas fir with a hole straight-thru for a beer spigot and a partial groove in the bottom that allows it to be attached to a desktop with a C-clap. It started out as a part of a jockey-box, but after reading a fair amount, I decided that for the purposes of a party (or a wedding), the 5-gallon kegs usually get finished before they can cool down, and having the keg under the desk in a bucket of ice would be cheaper and less foamy than trying to get a jockey box dialed in.

Anyway, it worked well, looked nice, and was fun to make with some scrap I had laying around. I re-sawed some of the CVG fir to glue to the sides so that it would be CVG all the way around. It seemed a shame to have only 2 pretty sides. I didn’t finish it – and I probably should given the wet nature of beer – but unfinished fir just looks so lovely. Personally, I like it better with the short tap-handle. Next step will be to make a matching handle.

0 Responses to “Banquet draft tower – for all your office party needs”


  • No Comments

Leave a Reply